Starting Up, Operating And Stopping The Band Saw; Important; Cutting Blade Speed - Super Ego 189 Manual De Usuario

7. OPERATING CONTROLS AND ADJUSTMENTS
A
Elements of Fig. 9 - 10
A: Unblocking actuator
B: Start up actuator
7.3 STARTING UP, OPERATING AND
STOPPING THE BAND SAW

IMPORTANT

When the machine is not in use, the power
switch must always be in the OFF position to
avoid injury.
To start up the band saw first press back the unblocking
actuator (A) and then raise the start up actuator (B) -
(Fig. 11).
B
Fig. 10
B
Fig. 11
39
Both actuators are located on both the upper and the
lower sleeve. The band saw may be started up by using
either the actuators on the upper handle or using those
on the lower handle.
To keep the band saw running, keep both actuators
pressed at the same time (Fig. 12).
To stop the band saw, release either of the two actuators.
Elements of Fig. 11-12
A: Press the unblocking actuator backwards
B: Press the start up actuator into the upright position.

7.4 CUTTING BLADE SPEED

To change the cutting blade speed, turn the operating
control (A) to the speed you need (between "1" and "6"
from the lowest to the highest speed) - (Fig. 13, 14).
A
Fig. 12
A
Fig. 13