Motor Settings - Bradley Aerix+ Manual De Instrucciones

Adjusting Dryer Controls
Table 4
Motor Setting
Heater "OFF"
Hi
Med
Low
The hand dryer has adjustable controls for (3) levels of operation – Hi, Med and Low. The dryer can be operated with
the heating element "ON" or "OFF". The dryer's power usage for the range of operation is shown in Table 4.
Note: The factory setting for the dryer controls is motor "Hi" and heater "ON".
The adjustable dryer controls are located on the printed circuit board inside the dryer's wiring compartment.
To adjust dryer controls:
1. Disconnect the power source.
2. Use the security hex key supplied to turn the cover mounting screws clockwise to remove the cover from the dryer.
3. Remove the wiring compartment cover to access the adjustable controls (see Fig. 1).
4. Adjust motor setting and heater as desired, and replace wiring compartment cover.
5. Reassemble the dryer cover using the security hex key supplied to turn the cover mounting screws counter-clockwise
and tighten until snug. Do not over tighten.
07/12/17
Power Usage (Watts)
Heater "ON"*
800 1200
575 975
400 800
WWW.RESTROOMDIRECT.COM
* Heating element wattage is 400W maximum.

Motor Settings

Hi / Med / Low
Bradley P20-200 Rev. B; ECN 17-15-021
5
704 • 937• 2673
Fig. 1
Heater Options
On / Off
129 Oakpark Dr., Unit A, Mooresville, NC 28115