Electrial Hook Up Ofthe Hood - ICIDIAI 3D9BL Manual De Instalación, Uso Y Mantenimiento

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 34
ELECTRIAL HOOK UP
OFTHE HOOD
&
Piace the metal box containing the elec-
tronic components at a distance of no less
than 65 cm from gas-operated cook tops or
in any case, 65 cm from the extraction point
of the hood.
&NorA&
We recommend installing the metal box
containing
the electronic components
least 10 cm above floor level andata suita-
ble distance from ali heat sources (e.g. oven
sides or cook top).
&cAUrloN&
This appliance is fitted with an H05 WF 3
conductor, 0.75 mm2 (neutral, phase, and
ground) power cable. This can be hooked
up to a 220 - 240 V mono-phase electrical
network by way of a CEI 60083 regulation
power socket that must remain accessible
after installation, in conformity to installa-
tion regulations.
We decline ali responsibility in case of ac-
cident caused by a lack of ground connec-
tion or incorrect ground connection. The
appliance must be fed through a differen-
tial protection device (RCD), with a nominai
residua! current not exceeding 30mA. lf the
power cable is damaged, cali the after-sales
service to avoid any risk.
This appliance is fitted with an H05 WF 3
conductor, 0.75 mm2 (neutral, phase, and
ground) power cable. This can be hooked
up to a 220 - 240 V mono-phase electrical
network by way of a CEI 60083 regulation
power socket that must remain accessible
S-004
N
GB
after installation, in conformity to installa-
tion regulations.
&oANGER&
lf the hood presents some form of anomaly,
unplug the appliance or remove the fuse
corresponding to the appliance's
line.
lf
the appliance has no plug
easily accessible,
ted to
cut it off from
at
device
must
have
contacts
on ali
ELECTRIAL HOOK UP
&NorA&
This appliance conforms to the European
Directives 2006/95/EC (Low Voltage Direc-
tive)
and
Compatibility).
When you install
maintenance,
power
source
or removed. Electrical hook
aut
before the appliance is installed
net.
Check that:
the
power
• power
The
diameter of
installation regulations.
or if
the plug is
then
a device needs to be
the mains electricity; this
an
opening distance
poles
of at least 3 mm.
2004/108/EC
(Eiectromagnetic
the appliance
it
must be unplugged
or
the fuses
must
be
up
must
source is sufficient,
cords are
in good condition.
the cables conforms to
power
not
fit-
between
and
carry
aut
from
the
disengaged
be
carried
in
the
cabi-
19

Publicidad

Tabla de contenido
loading

Tabla de contenido