ESAB Origo Feed 484 P5 Manual De Instrucciones página 24

NOTE: DO NOT USE THE NEUTRAL OF THE POWER SUPPLY SYSTEM
FOR GROUNDING.
All electrical connections must be firmly tightened to avoid sparkling risks,
overheating or circuit voltage drop.
5.3) Installing the wire feeder
1)Connect the wire feeder to the power source through the command cable.
2)Fix the welding cable to the + terminal of the power source in the terminal of the wire feeder.
3)Fix the hose of the gas pressure regulator to the inlet nipple of the back solenoid valve of the wire feeder.
4)Install the welding gun (see specific manual).
5)Install the wire.
6)Install the feed rollers according to the wire type and diameter to be used.
TABLE 5.1
Diameter Type
Ø mm
0,6 - 1,2 Fe,Ss,C
0,9 - 1,6 Fe,Ss,C
1,2 Fe,Ss,C
1,4 - 1,6 Fe,Ss,C
2,0 - 2,4 Fe,Ss,C
1,2 - 1,6 C
2,0 C
2,4 C
1,0 - 1,6 Al
1,2 Al
C=Cored
Wire
24
Origo™ Feed 484 P5
ATTENTION!
The wire feed mechanism can be hurt. Be carefull.
1 2
Feed Arm Output
Roller Nozzle
0703957 0703270 0707605
0711860 0711863 0707605
0710718 0710720 0707605
0710719 0707899 0707605
0710719 0707899 0710525
0700278 0702570 0707605
0700278 0702570 0710525
0710522 0710523 0710525
0711861 0711864 0707896
0711862 0711865 0707896
FEED ROLLERS
3 4 Groove
Intermediare Type
Nozzle
0703996 V
0703996 V
0703996 V
0703996 V
0710524 V
0700153 V - K
0700153 V - K
0710721 V - K
0703996 U
0703996 U
K = Knurled
= Groove
Identification 1
1 0,6 - 0,8 0,9 - 1,0
6 0,9 - 1,0
7 1,2
2 1,4 - 1,6
2 1,4 - 1,6
3 1,2 1,4 - 1,6
3 1,2 1,4 - 1,6
4 2,4 Not Used
U4 1,0
U4 1,2
2 3
1,2
1,2 1,4 - 1,6
1,2 1,2
2,0 2,4
2,0 2,4
2,0
2,0
Not Used
1,2 1,6
1,2 1,2