RCA DTA800 Manual De Usario página 6

Setting up
Step 3: Program the supplied
remote control
You can control TV sets of all major brands
after programming
remote control with the PGM key. RCA
TV sets can be controlled
programming. Refer to the steps below and
the separate Program Code leaflet to guide
you through the programming.
1. Refer to the separate Program Code
leaflet. Look for the brand of your TV
set and a 3-digit program code next to
it. There may be more than one program
code available. Choose anyone
Program codes/C6digos de programa
Admiral 002, 128, 183, 189
Advent 191, 258, 260, 275
• If your TV set is not on the list, skip the
rest of Step 3 and go to "Step 4: Initial
setup of the Converter Box".
2. Press PGM on the remote control. The
signal indicator
3. Enter the 3-digit program code with the
number keys. Press OK for confirmation.
The signal indicator will be off when the
program is done.
4. Press the volume keys on this
remote control to check if
they can adjust the volume
of your TV set.
• If you fail to control your TV set, repeat
steps 2 to 4 to program again. Try
another program code if there is more
than one for your TV brand.
signal
• If the indicator
blinking four times, you may have
entered the wrong code. Repeat steps 3
to 4 to program again. Make sure you
have correctly entered the code.
6
the Converter Box
directly without
of them.
on it remains lit.
signal
indicator
remains lit after
• You can still use your TV remote control
to turn on your TV set, select input
source and control the volume.
Step 4: Initial setup of the
Converter Box
C>
1. Press BOX on the remote
control to turn on the
Converter Box.
C>
2. Press TV (or use the TV
remote control) to turn on
the TV set.
3. Press INPUT up to four
times (or use the TV
remote control) to select
the channel on your TV set
to view images from the
converter box.
• The following screen will appear on your
TV when the correct channel is chosen.
Language
Choose the language to be used in the menu system
IBiII
Menu texl is r;Itsplayed in English
Espanal • 2 texto se
EI del menu exhibe en
espallol.
Franyais - 3
Letextedesmenuseslafficl1een
fran~is
• If you cannot see the above screen on
your TV set, check that:
1) if the converter
on,
2) if you have programmed
control so that the TV input channel can
be selected correctly,
3) if you have correctly connected the TV
set with the Converter Box.
4. Press 1 (for English), 2 (for
Spanish) or 3 (for French) to
select the menu language.
5. Press 1 to start automatic
Channel Scan
Channel scan wmsearch
3rea.Youmayhavetore-adjusttheanlennaanr;!
retry the scan to capture all available channels
~Slartchannelsearch.
(
• To improve TV signal reception,
optional Smart Antenna
compatible for connection
Converter Box is recommended.
box has been turned
the remote
channel search.
for channels available in your
an
which is
with the
DTA800-B