Battery Installation; Mode Selection - smartheart 19-101 Manual De Instrucciones

BATTERY INSTALLATION

This unit includes 1 CR2032 battery, preinstalled.
Before first use, open the battery cover and remove the plastic
insulating strip. Replace the cover and the scale is ready for use.
It is necessary to replace the batteries when the display does not
turn on when being activated by stepping on the scale.
The battery compartment is located on the underside of this
scale.
1. Depress the clip on the battery compartment cover and
remove the cover.
2. Insert or replace 1 CR2032 batteries into the battery
compartment, the positive (+) is up. Always use new
batteries.
3. Replace the battery cover.
4. Dispose of batteries according to local disposal and
recycling regulations.
It is recommended to remove the batteries if the unit will not be
used for an extended period of time.
When batteries are first in-
stalled, the display will briefly
show all 8s.
MODE SELECTION–POUND (LB), KILOGRAM (KG), STONE (ST)
This scale will automatically default to pound (LB) unit
of measure.
1. To change the unit of measure mode, press the UNIT button
on the back side of the monitor.
2. The display will alternate between 'lb' 'kg' and 'st'.
3. When the desired unit of measure is shown, release the
button. The unit of measure mode is now set.
6 • ENGLISH
When the display shows 0.0,
it is ready for measurement.
UNIT
MODE/
UNIT
Button