Bushnell MARINE Manual Del Usuario página 6

you to see the compass heading clearly, press the button atop the right tube. If the light
is dim or does not come on, replace the batteries. If the light does not operate after
replacing the batteries, please contact the Bushnell
dealer nearest you.
HOW TO CHANGE THE BATTERIES
To change the battery, use a thin coin to remove the
battery cover by turning it counter-clockwise. Remove
the two batteries. The batteries have a (+) on the front
and a (-) on the back. Be sure to insert the new batteries
with (+) signs in the same direction. Replace the battery
cover by turning it clockwise.
6
USING THE COMPASS ILLUMINATOR
The BUSHNELL MARINE compass model comes with
built-in LED compass illuminator for use at night and
in low light conditions. (Incidentally, the compass is
built into the left tube of the binocular but the push
button control for the light and the battery are located
in the right tube. This was done to minimize the chance
that electrical interference might affect compass
performance.) When the ambient light does not permit