Cleaning And Maintenance; Replaceable Components - IRIS IC-FAC2U Manual De Instrucciones

CLEANING AND MAINTENANCE

How to Store: When the product is not in use for an extended period of time, cover the unit with a plastic bag,
etc., and then store it in a dry location away from direct sunlight.
Warning:
Cleaning and maintenance must be done after unplugging the vacuum.
Notice:
Please do not splash water on the vacuum body as this could cause damage.
Use a diluted neutral cleaning agent.
Use of strong cleaning agents such as amyl acetic ester, alcohol, oil, etc. can cause fading, deformation or breakdown.
Vacuum Body:
Fully wring out a rag and use it to wipe down the body and any
remaining cleaner.
Dust Indicator:
Remove the dust cup and clean both sides of the sensors with a
cotton swab.
• Please clean regularly to avoid dust buildup, causing sensor
to function poorly.
Collection Head:
• Clean hair, string and other small objects from the dust
intake port using tweezers to prevent dust buildup and
decreased suction. Please clean it regularly.
• Please clean dirt on the agitator with a brush.
• Clean regularly to prevent dust buildup causing sensors to
function poorly.
Dust indicator
Rollers
Agitator
Dust intake port
7

REPLACEABLE COMPONENTS

Please follow the instructions below for replacing the mesh dust filter, mesh exhaust filter, and battery.
Dust Filter Replacement
*Please see P6 "Clear Dust" for how to remove filter set.
1. Remove the dust filter.
• Hold the filter cap with fingers.
• Turn the dust mesh filter until latches no longer line up.
• Remove the filter from the filter cap.
2. Insert new dust filter.
• Hold the filter cap with fingers.
• Line up the latches, insert the new mesh filter, and
twist to lock into place.
• Press the filter in the dust cup until it clicks into place.
Exhaust Filter Mesh Replacement
1. Remove exhaust filter cover.
• Turn the filter cover counterclockwise, and pull it off.
TURN
Filter Cover
2. Change exhaust filter.
• Remove filter and insert new filters.
*Side with a hole is placed facing inwards.
3. Replace filter cover.
• Place filter cover back on the vacuum and turn it
clockwise to lock into place.
Filter Cap
latch
Mesh Filter
Latch to line up
REMOVE
Filter Cover
close
open
New Filter
Side with a hole is
placed facing inwards.
replace
Filter Cover
close
open
8
latch
close
open
close
open