Bpt TA/P1 Manual Del Usuario página 12

Warnings
• Read the warnings contained herein with care as they furnish important instructions regard-
ing safe use, installation and maintenance.
• After removing the packaging check the condition of the unit.
• The system must be installed in compliance with current safety standards.
• The manufacturer declines all liability for any damage as a result of improper, incorrect or
unreasonable use.
• Should the unit be in need of repair contact only a technical support centre authorised by
the manufacturer.
• Failure to comply with the above instructions may compromise the unit's safety.
• Install the unit in a position which is suitable for correct room temperature measure-
ment, for example on an internal wall. Avoid installation in alcoves, behind doors or
curtains, or near heat sources.
• Only clean the thermostat with a soft cloth dampened with water.
Characteristics
TAP1 is a room thermostat for indoor use that must be connected to the BPT home auto-
mation bus.
The device comes with an input (
perature sensor or a type PT1000 temperature sensor; the input can also be used as a digital
input (window contact, for instance).
For best performance and to enable the best use of this device's characteristics and func-
IT
tions please read this manual carefully and keep it available for future reference.
Components of the device
EN
DE
FR
back-box
ES
PT
hole-blanking adaptors
12
) which can be connected to an OH/STI remote tem-
supports A, B, C, D
cover
fixing screws