VENOM Stronghold Solo Manual De Funcionamiento página 6

INSTRUCTIONS FOR USE
1) Set up your Stronghold Solo and battery charger on a non-flammable surface away
from flammable objects, chemicals, or other potentially hazardous materials.
2) Insert the charge lead and the 2-6S balance block, if applicable, through the power
lead hole in the Stronghold Solo. Power to the charger should be turned off during
this step to prevent the possibility of shorting the wires if metal connectors touch
the sides of the Stronghold Solo.
3) Turn On power to your charger.
4) Connect battery to the charge leads and place inside Stronghold Solo.
5) Close the lid to the Stronghold Solo and secure with the lid latch.
6) Start charge procedure of the battery. Do not leave batteries unattended while
charging. Consult the charging instructions that came with your battery.
WHAT TO DO IF A BATTERY DOES FAIL
1) Allow the battery to finish the failure completely before approaching the box. Fumes,
flames and other chemicals are quite hazardous if inhaled or ingested. Be prepared
with a chemical fire extinguisher to put out any remaining parts of the battery. Allow
everything to cool down before handling.
2) Remove all power to the charger that was in use.
3) Wearing rubber gloves and eye protection, remove the remains of the failed battery
from the Stronghold Solo. Dispose of them in a plastic bag and place them in the
trash.
4) The Stronghold Solo can be re-used. Battery residue and soot can be washed out
with ordinary soap and water.
stronghold
0672
[ 5 ]