Introduction; Safety Instructions; Product Description - Mettler Toledo InFlow 76 Serie Guía De Configuración Rápida

InFlow 76X Series
1

Introduction

The METTLER TOLEDO InFlow
are intended for use in conjunction with specified
METTLER TOLEDO housings, namely InFit
In order to ensure trouble-free use, please read through
this quick set-up guide and the operating instructions
carefully before commissioning. Operating and maintenance
should be carried out only by trained personnel and staff
who have read and understood the operating instructions.
2

Safety instructions

h
Notice: Before every start-up, the housing must be checked
for:
– Damage to the connections, fastenings, etc.
– Leakage
– Perfect functioning
– A uthorization for use in conjunction with other plant
equipment and resources.
h
Notice: The manufacturer / supplier accepts no responsibility
for any damage caused by unauthorized attachments
or for the incorporation of spare parts which are not of
METTLER TOLEDO provenance. The risk is borne entirely by
the operator.
a
Caution: Before the housing is put into operation, the
operator must have already clarified that use of the housing
in conjunction with the other associated equipment and
resources is fully authorized.
a
Caution: A defective housing may neither be installed
nor put into operation. Faulty containment or installation
out of conformance with regulations and instructions
can lead to the escape of medium or to pressure surges
(explosion), potentially harmful both to persons and to
the environment.
a
Caution: If an electrode / sensor / housing is broken, it must
be replaced immediately.
a
Warning: Before dismantling the housing or commencing
any maintenance work on it, ensure that the equipment
in which the housing is installed is in a safe condition
(depressurize, no explosion risk, empty, rinse, vent, etc.)
a
Warning: Please observe, read and fully understand the
special conditions of use for installation in ex-classified
areas.
3

Product description

The label on the housing contains the following information:
Manufacturer of the housing and contact details:
METTLER TOLEDO
www.mt.com
Im Hackacker 15, CH-8902, Urdorf, Switzerland
Type of housing family:
InFlow 76X
Part number:
Part No.
Serial number:
SNR
Maximum permissible pressure:
PS
Maximum permissible temperature:
TS
Ex-classification testing notified body number:
CExxxx
See instruction manual for detailed description:
See instruction manual
InFlow 76X Series
Printed in Switzerland
76X flow-through housings
®
© 07 / 2019 Mettler-Toledo GmbH
en
15
, or InTrac
® ®
30 313 398 B
.