Maintenance And Storage; Periodic Inspections - Kong KOSMOS Manual De Instrucciones

granted and therefore it is essential for the user to carefully judge the situation
beforehand to guarantee adequate protection.
G) It is strictly forbidden to modify and/or repair the product: The Manufacturer
shall not be held liable for any damages, injuries or death caused by: improper
use, product modifications, repairs by unauthorized persons or use of non-original
spare parts
H) During transportation avoid exposure to U.V. radiations and sources of heat and
avoid contact with chemical reagents or other corrosive substances, and adequately
protect any pointed or sharp parts. Warning: never leave your equipment in a car
under the sun!
I) For the sake of your own safety, it is essential to make sure that the product
was sold to the public: complete, in their original packaging and with the relative
information. It is compulsory for dealers selling products in countries other than the
original destination to check and supply the translation of this information.
L) This product has been tested and inspected piece by piece in conformity with the
Quality System certified to the UNI EN ISO 9001 international standard. Personal
protective equipment is certified by the notified body indicated in the relevant
product instructions. Warning: laboratory tests, inspections, information and
norms do not always manage to reproduce what actually happens in practice
so that the performances under real conditions when using the product in a
natural environment can often differ considerably. The best information can
be gained by continual practice under the supervision of skilled and qualified
instructors.
2 – MAINTENANCE AND STORAGE
Product maintenance consists of:
- cleaning: frequently wash the product with lukewarm (max. 40°C) drinking-water
where necessary, you can also add some gentle detergent. Rinse and leave to dry
naturally away from direct sources of heat, do not centrifuge.
- disinfection (if necessary): soak the product for an hour in lukewarm water adding
disinfectant, then rinse again with drinking-water, dry and lubricate. Avoid autoclave
sterilization for textiles.
- lubrication (for metallic products only): frequently lubricate the mobile parts with
silicone based oil. Avoid contact between oil and textile parts. This job must be done
after cleaning and completely drying.
Storage: after cleaning, drying and lubrication place the loose equipment in a
dry (40-90% relative humidity), fresh (temperature 5-40°C) and safe (avoid U.V.
radiation) place, chemically neutral (absolutely avoid salty environs), away from
sharp edges, sources of heat, dampness, corrosive substances or other possible
detrimental conditions. Do not store when wet!
3 – PERIODIC INSPECTIONS
We would also strongly advise having pre and post use controls carried out by
qualified persons. Unless otherwise specified by stricter provisions of law, it
is recommended to have a competent person to perform an accurate product
inspection on an annual basis. Periodic inspections results shall be recorded in
the product control card. A control card shall be provided for each component,
subsystem and system (please find a sample attached). Periodic inspections shall
as well check that product marks are clearly legible.
4 – PRODUCT LIFE
Read point 1C very carefully. Lifetime of metallic devices is theoretically unlimited
CS
DA
DE
EL
EN
ES
FI
FR
IT
NL
PT
RU
SV