Intended Use; Installation And Connection; Malfunction Remedy - Pontec PondoSolar LED Set 3 Instrucciones De Uso

Intended use

Only use the product described in this manual as follows:
• Use of LED spotlights in fountain systems and ponds.
• Use of LED spotlights above water and underwater.
• Operate in accordance with instructions.
• Adherence to the permissible water quality.
The following restrictions apply to the unit:
• Do not use for commercial or industrial purposes.
• Do not use in conjunction with chemicals, foodstuff, easily flammable or explosive substances.

Installation and connection

• The LED spotlights can be submerged or installed in a dry position.
• For dry installation, keep a distance of at least 50 cm from any flammable materials.
– Danger of fire: Do not cover the unit!
How to proceed:
 B
1. Assemble the fastening set for the solar module.
2. Push the fastening set into the holder on the solar module and fasten the solar module in the ground using the
ground stake.
– Install the solar module so that it is exposed to direct sunlight and align it in relation to the sun to ensure maxi-
mum energy yield.
– Ensure that the connection cable is routed downwards.
3. Connect the connection lines of the LED spotlight and the solar module using the plug and socket.
– Hand-tighten the union nut.
4. Switch on the power supply for the LED spotlights on the switch on the solar module.
– The light sensor integrated in the solar module automatically switches on the LED spotlights at low light (twilight).
5. Install and align the LED spotlights.

Malfunction remedy

Malfunction
LED spotlight does not light up
Illuminating power decreasing
Short lit period
Cause
No connection to the solar module.
Switch on the solar module is set to "OFF"
The solar module is soiled.
Bulb defective
Water inside the spotlight housing
Lamp glass soiled
Insufficient sunlight
The integrated rechargeable battery was
charged insufficiently
The integrated rechargeable battery is used up
Remedy
• Connect the LED spotlights and the solar
module
• Connect the plug connectors correctly
Set the switch to "ON"
Clean the solar module
Dispose of the unit
Dispose of the unit
Clean lamp glass
Align the solar module to the sun.
Align the solar module so that its position in re-
lation to the sun is ideal
Dispose of the unit
- EN -
7