Maintenance And Cleaning - IKEA FIXA Manual Del Usuario

When removing the battery from the
machine, actuate the trigger switch
(4) until the battery is completely
discharged. Unscrew the screws in
the casing and take off the casing shell.
Disconnect the connections on the battery
and remove the battery (see illustration A).
INSTRUCTIONS FOR USE
Regulating the shaft speed
It is possible to regulate shaft speeds from
zero to maximum by altering the pressure
applied to the trigger.
Reversing the direction of rotation
You can reverse the direction of rotation by
using the selector above the trigger.
To lock the trigger, set the selector to the
mid position between the right and left
options.
Adjusting the tightening moment
Turn the torque regulator to the desired
position. Settings 1-15 are used for
tightening/loosening screws (the higher the
value, the greater the tightening moment).
Select the drill symbol before using the tool
for drilling.
Keyless chuck
Your drill has a keyless chuck so that you
can simply tighten or release drill/driver
bits.
To open/close the chuck hold the rear ring
and rotate the front sleeve.
WARNING: RISK OF TRAPPING
Do not hold the front sleeve of the chuck
with one hand at the same time as you open
or close the jaws of the chuck with the help
of the drill/screwdriver's motor.
Mounting drill/driver bits
Set the drill/driver´s trigger in mid position.
Adjust the chuck until the opening is slightly
larger than the shaft of the drill bit that you
wish to use.
Insert the drill bit into the chuck.
Tighten the chuck against the drill as
described above (Keyless chuck).

MAINTENANCE AND CLEANING

Before any work on the machine (e.g.
maintenance, tool change, etc) as well
as during transport and storage, set the
selector for rotation right/left to the
centre position. Unintentional actuation of
the trigger can lead to injuries.
For safe and proper working, always
keep the machine and ventilation slots
clean.
ENVIRONMENTAL DISPOSAL
INSTRUCTIONS
Help to protect the environment
Information (for private households)
about the environmentally sound disposal
of electrical and electronic equipment in
accordance with the WEEE directive (Waste
Electrical and Electronic Equipment).
This symbol on electrical and electronic
products and the documentation that
accompanies them indicates that these
products may not be discarded together
with ordinary household waste. Instead the
products must be taken to a designated
9