Craftsman 917.881060 Manual Del Proprietário página 10

OPERATION
GASOLINE ELECTRIC AUGER DISCHARGE CHUTE CONTROL LEVER
START BUTTON CONTROL
LEVER DRIVE SPEED DEFLECTOR REMOTE
RECOIL X CONTROL LEVER CONTROL LEVER
\
STARTER
HANDLE
TRACTION
CHUTE DRIVE
CHOKE DEFLECTOR CONTROL
CONTROL LEVER
SAFETY
IGNITION
KEY
ON / OFF
SWITCH
CHUTE
LH TURN
TRIGGER
LIGHT
CLEAN-OUT TOOL
KNOB
NOTE: ITEMS ABOVE
ARE SHOWN IN
THEIR TYPICAL
LOCATION ON THE
ENGINE. ACTUAL
LOCATION MAY VARY
WITH THE ENGINE
ON YOUR UNIT.
\
\
\
TOOLBOX
DRIFT CUTTER
PLATE
AUGERS
FIG. 10
MEETS A,N,S,I, SAFETY REQUIREMENTS
Our snow throwers conform to the standards of the American National Standards institute,
Toolbox - used to store spare shear bolts, Iocknuts and
wrench,
Safety ignition key = must be inserted for the engine to
start and run, Remove when snow thrower is not in use,
Electric start button - used for starting the engine,
Recoil (auxiliary) starter handle-used for starting engine,
Primer - pumps additional fuel from the carburetor to the
cylinder for use when starting a cold engine.
Choke Control - used for starting a cold engine.
ON / OFF switch = used to STOP the engine.
LH and RH turn triggers- used to steer the snow thrower.
10
Drive speed control lever = used to select forward or
reverse motion and speed of snow thrower,
Traction drive control lever- used to engage power-pro-
pelled forward or reverse motion of snow thrower,
Auger control lever - used to engage auger motion
(throw snow),
Discharge chute control lever - used to change the
direction the snow is thrown,
Deflector remote control lever - used to change the
distance the snow is thrown,
Skid plate - used to adjust height of scraper bar from ground,
Drift cutter - used to cut through deep snowdrifts,