Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
8.
Turn fuel valve to the ON
position, 1/4 turn
counterclockwise.
9.
Move the choke control lever to
the CHOKE ON
the throttle control to the FAST
position. NOTE: No choke is
Choke
Control
Fuel Valve Knob
needed to start a warm engine.
10. Pull starter grip slowly until you
feel resistance, then pull briskly.
Return starter grip gently. Pull
rope with a rapid full arm stroke.
Let rope rewind slowly. Repeat if
MOVING PARTS, OR FIRE RESULTING IN DEATH. BEFORE PERFORMING
ANY MAINTENANCE OR REPAIR, DISCONNECT SPARK PLUG WIRE, LET
ENGINE COOL AND RELEASE ALL WATER PRESSURE. THE ENGINE
CONTAINS FLAMMABLE FUEL. DO NOT SMOKE OR WORK NEAR OPEN
FLAMES WHILE PERFORMING MAINTENANCE.
To ensure efficient operation and longer life of your pressure washer, a routine
maintenance schedule should be prepared and followed. If the pressure washer
is used in unusual conditions, such as high-temperatures or dusty conditions,
more frequent maintenance checks will be required.
D25852
position and
Throttle
Control
MAINTENANCE
WHEN PERFORMING MAINTENANCE, YOU MAY BE
EXPOSED TO HOT SURFACES, WATER PRESSURE,
necessary.
pulls, pull the trigger to relieve the
pressure.
11. If the choke was used to start
the engine, move the choke lever
to the OFF position.
12. Depress trigger on gun to start
water flow. Release trigger to
stop water flow.
13. Adjust nozzle spray for the task
being performed. See How To
Use Wand instructions in this
section.
with very hot engine muffler during
or immediately after use of your
pressure washer.
14- ENG
If the engine does
not start after two
DO NOT let hoses
come in contact
Publicidad
Capítulos
Tabla de contenido
