Briteq LDP-ACCUSPOT 7TC Manual De Instrucciones página 9

ENGLISH
WIRED SOLUTION
 Same as the MIXED solution but the first unit in the chain also receives the DMX-signal from a
DMX-cable plugged in its DMX-input connector.
Note: when a DMX-signal is detected on the DMX-input connector, this "wired" DMX-signal will take
precedence over the wireless DMX-signal.
USING THE (OPTIONAL) COVERS
The LDP-ACCUSPOT 7TC comes in black color, not always the best choice while placed in front of a white
wall. Therefore you can buy optional plastic covers to put around the projector.
You can put publicity on these covers or paint them to adapt the projectors for the event, additionally the
covers also mask the LEDs so people only see the beam.
Once the cover is worn, you can simply throw it away and use
a new one...
 INDOOR USE (IP20): you can use the plastic cover without
the transparent top part.
 OUTDOOR USE (IP43): you can use the plastic cover with
the transparent top part to avoid rain from entering the
projector.
Attention: this does NOT mean that the projector now
becomes full waterproof! It's only protected against
occasional rain!
HOW TO SETUP:
MAIN MENU:
 To select any of the menu options, press the MENU button up to when the required option is shown on the
display.
 Select the function with the ENTER button. The display will blink.
 Use DOWN and UP button to choose the desired menu option.
 Once the required menu option is selected, press the ENTER button to select.
Remark: Press the MENU button for about 2 seconds to return to running mode or just wait 8 seconds.
"CoLo" Color Preset Mode
Used to choose one of the 16 standard preset colors. You can also define your own custom color,
based on individual settings for red, green and blue.
 Press the MENU button until "CoLo" is shown on the display.
 Press the ENTER button to select.
 Use DOWN and UP button to select one of the available options:
 Select one of the preset colors "Co 1" to "Co16" and press ENTER to confirm.
 Select "Manu" to make your own color and press ENTER to confirm. Now you can set the 3 colors to
make your own custom color:
 "red": press ENTER. Then use the DOWN and UP buttons to set the value between 000 and 255.
Confirm with the ENTER button. Use the DOWN and UP buttons to select the next color.
 "Gree": press ENTER. Then use the DOWN and UP buttons to set the value between 000 and
255. Confirm with the ENTER button. Use the DOWN and UP buttons to select the next color.
 "blue": press ENTER. Then use the DOWN and UP buttons to set the value between 000 and
255. Confirm with the ENTER button. Use the DOWN and UP buttons to select the next color.
 Once the right settings are done; press the MENU button for about 2 seconds to return to running mode.
"dIMM" Manual master dimmer
Used to set the level of the master dimmer while in standalone mode.
 Press the MENU button until "dIMM" is shown on the display.
 Press the ENTER button, the display starts blinking.
 Use DOWN and UP button to select a value between "0" (no output) and "100" (full output).
 Once the level is set, press the ENTER button save it.
To go back to the main menu without any change press the MENU button shortly.
If you want to go back to normal running mode: press the MENU button for about 2 seconds.
BRITEQ
®
7/69
USER MANUAL
LDP-ACCUSPOT 7TC