Installation Instructions; Required Tools - Lithonia Lighting QTE LED P3 Instrucciones De Instalación

FIXTURE PACKING LIST
Description
1) LED Light Fixture ........................................................................................1
2) Threaded Knuckle .........................................................................................1
3) Locknut ........................................................................................................1
4) Mounting Plate & Gasket* ...........................................................................1
5) Yoke .............................................................................................................1
6) 1/2" 8-32 & 10-24 Mounting screws* ..........................................................4
7) Wire Nuts* ....................................................................................................3
*Contained in parts packs
Mounting Hardware and
Silicone Sealant Required - Purchase Separately

REQUIRED TOOLS:

Remove fi xture components and parts pack. Check to ensure all
parts are included. Note: Account for small parts and destroy packing
material, as these may be hazardous to children.
Turn OFF Power at circuit breaker box.
CAUTION: Do not rely on wall switch alone to turn off power.
Not suitable for use with dimmers, motion sensors or other remote devices.
THK - Threaded Knuckle Mounting:
For mounting to a wet location j-box, thread included mounting plate (4)
onto knuckle (2) and tighten locknut (3) to secure or thread knuckle into
a 1/2" NPS hole in a compatible mounting apparatus. Note: Seal arm
thread using Tefl on tape or silicone sealant. Refer to wiring instructions
for power connection.
To adjust the tilt angle of the fi xture, loosen the Philips Head screw in
the knuckle, rotate fi xture to the desired angle and re-tighten screw.
1) Light Fixture
2) Threaded Knuckle
YK - Yoke Mounting:
Mount fi xture to the desired bracketry with 3/8" bolts, lock washer, and
nut (not provided). Tighten to 30ft-lbs. See template of yoke bracket hole
pattern below.
Quantity
4) Mounting Plate
3) Locknut
page 3

INSTALLATION INSTRUCTIONS

The Yoke Mount option is provided with 18AWG power supply cord.
The power supply cord has 5/16" inch outside diameter (O.D.). A UL
LISTED water tight cord connector suitable for use on 5/16" inch
diameter size wet location fl exible cord shall be required in order to
install onto a wet location outdoor junction box. See image below.
To reduce risk of water entry when installing onto an outdoor junction
box ensure that a Tefl on tape or silicone sealant is applied on the
threaded portion of the fi tting. It is recommended that the water tight
cord connector be installed so that power supply cord exits towards the
ground. If existing wiring does not allow for installation of wires exiting
towards the ground, the use of an elbow suitable for wet location use
is recommended so that cord can exit towards the ground. See images
below.
To adjust the tilt angel of the fi xture, loosen the 1/4-20 Philips head
screw on both sides of the yoke, adjust to desired angle and re-tighten
screws to secure.
CAUTION: WIRING AND FIXTURE OPERATION
Make sure power is turned off . Ensure input power is 120V,
To Ground fi xture use Wire Nut to connect the (copper) house supply
ground wire & the (green) fi xture ground wire. Note: If house wiring
does not include a ground wire, consult your local electrical code for
approved grounding methods.
For proper connection, place wire nut over
wires and twist clockwise until tight.
To connect supply wires use Wire Nuts to connect the black fi xture wire
to the black power supply wire and the white fi xture wire to the white
(neutral) supply wire.
5) Yoke