Publicidad
Heel Back Needle Position Setting For Motors with Foot Lift (Enduro
Setting up Number 4
a. Keep "▼" button pressed for several seconds, until LED
display indicates "SET.0".
b. Press "▲" button 4 times. It will now indicate "SET.4", which
means "Setting up No. 4".
c. Quickly press and release the "▼" button and the LED
will indicate the current heel back position of the needle,
"HbP.d" or "HbP.u".
d. To change from needle down position "HbP.d" to needle up
position "HbP.u" quickly press and release the "▲" button
and the LED will indicate "HbP.u", which means Heel Back
Position Up.
OR
e. To change from the needle up position "HbP.u" to needle
down position "HbP.d" quickly press and release the "▼"
button and the LED will indicate "HbP.d", which means Heel
Back Position Down.
f. Setting will automatically be saved 5 seconds after no
buttons are pressed. The motor returns to "ready" status.
Notes:
• Heeling back the first time causes the foot to raise and stay
raised until released.
• Heeling back the second time causes the needle to go or
stay in the UP or DOWN position as set above.
• If at any time this cycle is interrupted by pressing the
treadle forward and starting to sew, then the sequence
will be automatically reset.
www.endurosaves.com
ENGLISH - 9
SM1050-2PF)
™
current position
current position
default "ready" status
Either "POS.d" or "POS.u" will indi-
cate "ready" status, depending on
how the needle position is set.
alternate "ready" status
Publicidad
