Switching power supply/Battery charger
EN 60950-1
The IPS12060S switching power supply/battery charger has been designed and manufactured to the
highest standards of quality, reliability and performance adopted by INIM Electronics. INIM Electronics
guarantees that the components selected for this product will operate properly within their specifications
when the environmental conditions outside the enclosure comply with Class 3k5 (EN 60721-3-3).
The IPS12060S unit provides a regulated 13.8V and 2.5A maximum current by means of the +V
and -V terminals.
The outputs are overload, short-circuit and reverse polarity protected.
The unit can be equipped with an optional thermal probe (ProbeTH see the INIM catalogue) which
is capable of maintaining the battery charge current at the appropriate level for efficient battery
charging.
TECHNICAL SPECIFICATION
Mains supply voltage
Absorbed current
Output voltage
Operating output voltage
Maximum output ripple
Maximum output current
Connectable battery
(or equivalent with case flame class
UL94-V2 or higher)
Unreplaceble protection fuse (F1)
Operating temperature
Isolation class
Dimensions (W x H x D)
Weight
A
Mains input terminal board
B
Output terminal board
C
Output connector
D
Thermal probe connector
Serial port connector
E
(reserved)
F
G
Ground fault signalling jumper input
H
Anchor screw hole (Ø 3.25mm)
IPS12060S
providing 3A @ 13.8V
230V~ (-15%/+10%)
50/60Hz
0.5A (max)
13.8V
from 9 to 13.8V
1%
3A
12V – 7Ah or 17Ah
YUASA NP-12 FR
T 3.15A 250V
from -5 to +40 °C
I
138 x 42 x 87 mm
0.450 Kg
AC Input
230V ~ 50/60 Hz
+V, -V
RTH, FAULT, -V, +V
NTC
SERIAL
LED indicators
H
F
(±1%)
E
C
B
D
A
H
G