INIM Electronics IPS12060S Manual De Instrucciones página 4

The LED indicators [F] signal the presence of the mains voltage on the input terminals and the
proper operating capacity of the switching power-supply unit and its batteries.
Signalling
Green LED (DL1) Switching power-supply unit Off
Yellow LED (DL2) Mains operating properly
Removal of the jumper from the Earth fault signalling connector ([G]) deactivates the Earth fault
check.
If this appliance is used with a control panel all the obligatory status and fault signals must be
provided for and made available.
Connect the mains wiring to the input terminal board [A].
This appliance must be earthed.
Using the plastic cable band, bunch the mains wires and fasten them close to the
mains wire entry on the Switching power-supply unit.
Using the two mounting holes [H], secure the IPS12060S into its housing.
The output voltage can be drawn from either terminals [B] ("+V,-V"), or from the connector [C]
("+V, -V").
The output connector is also has "FAULT" and "RTH" terminals which are reserved for connection to
INIM control panels.
If you are installing a ProbeTH thermal probe, connect it to connector [D].
Attach the thermal probe to one of the batteries in such a way as to achieve an optimal level of
thermal conductivity.
The following maintenance operations must be performed regularly:
• Check that all wiring and connections are intact.
• Check that the appliance is operating properly.
• Check the battery efficiency.
These maintenance operations must be performed by qualified persons only.
For an installation that meets standard requirements, it is necessary to fit a
suitable sectioning device (bipolar) and protection on the electrical-wiring
upstream of the switching power-supply unit in accordance with the laws in
force (DM37/08).
INIM ELECTRONICS S.R.L.
Via Fosso Antico snc - Fraz. Centobuchi
63076 Monteprandone (AP) - Italy
Tel. +39 0735 70 50 07
Fax + 39 0735 70 49 12
www.inim.biz info@inim.biz
4
Signalling
Off
Switching power-supply unit
Mains operating fault
Installation
Maintenance
On
operating
ISO 9001 Quality Management Certificate
issued by BSI with certificate number
FM530352
INIM Electronics reserves the right to change
the information contained in the present insert
without prior notice.
IPS12060S
Blinking
fast slow
Overheated Output overload
Earth fault
ATTENTION!
ATTENTION!
/