Maintenance - Textron Greenlee Shear 30T Manual De Instrucciones

Maintenance

Lock out power to the Cutting Unit before performing
any maintenance.
Change the hydraulic oil annually or after 10,000 cycles.
Use ASTM 215 hydraulic fluid (or equal).
At least monthly, clean the inner track portions of the
Cassette Frame and Die Retaining Rails. Apply a moly
based, spray lubricant to the working surfaces. A dry film
lubricant such as Molykote 557 is recommended.
The material cutting dies are wear parts and will fail over
time. Order additional dies through Greenlee distributors.
The unit experiences a shock during each cutting
cycle which can loosen bolt connections over time.
Periodically check all fasteners on the Cutting Unit and
retighten where needed.
Available Dies
CAT NO. DESCRIPTION
158SSTRT 13/16 x 1-5/8 & 1-5/8 x 1-5/8 Single box profiles B-Line B22, B24, B26 & B52, B54, B56
158DSTRT 1-5/8 X 1-5/8 Double box back to back profiles
4STRT21 1-1/16 x 2-1/8 Single box 4D profiles
4STRT22 2-1/8 x 2-1/8 Single box 4D profiles
1458TROD 1/4-20, 3/8-16, 1/2-13 & 5/8-11 Threaded Rod
Note: The hot-dipped galvanized finished available from
many manufacturers will often leave beads of finish on
the product and can be more difficult to get through dies.
Greenlee / A Textron Company
COMPATIBILITY
Unistrut P1000, P1100, P2000 & P4520,
P4100, P4000
Powerstrut PS 200, PS 210 & PS 520, PS 500
Superstrut A-1200, A-1400 & B-1200, B-1400
B-Line B22A, B24A, B26A
Unistrut P1001, P1101, P2001
Powerstrut PS 200 2T3, PS 210 2T3
Superstrut A-1202 & B-1202
B-Line 4D21
B-Line 4D22
All mild steel rod
10
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070