Running A Program; Using A Cooking Program - Merrychef 402s Instrucciones De Instalación Y Operación

RUNNING A PROGRAM

Up to 256 named Cooking Programs are available in 16 Category groups. Each Category
group can contain up to 16 programs. Programs can be loaded into the oven memory from a
MenuKey or entered from the control panel.
Select a Program Category
Press this pad to display the
programs in this category
Breads
To start cooking select a Program Name
Press this pad to start cooking us-
ing the program Roll shown in the
display
Using a cooking program
1
Switch the oven ON
The oven heats up up to its pre-set temperature this will take
approximately 20 minutes.
The display will show the current oven cavity temperature.
The display will show the CATEGORIES screen when
cooking temperature is reached.
2 Taking all the necessary precautions to en-
sure you do not burn yourself, place the food
into the hot oven cavity and close the door.
Always keep the period that the door is open
to a minimum.
3
Press the program pad you wish to activate to
start cooking, the category & program name
and the remaining cooking time appear in the
display.
example: Category BREADS, Program ROLL
When the time reaches "00:00" the display shows cooking
completed and audible signal will be given.
Remove the food from the oven and close the door.
e.g. Breads
CATEGORIES
Pizza
Donuts
CAT 003
Breads
Press this pad for the second set of
Category groups ( 009 to 016 )
e.g. Roll
Program Category
Name: Breads
Breads
Ciabatta
Roll
Croissant
Prog 052
Press this pad for the second group of 8
programs in this category
(Programs 057-064)
Hot surface
hazard
01:35
14
CAT 005
CAT 006
CAT 007
CAT 008
PROG 053
PROG 054
PROG 055
PROG 056
BREADS
ROLL
Note:
When the cycle is interrupted or
stopped the oven will remain at
the pre-set temperature and the
food inside the oven will continue
to cook
Programs can be halted
and cancelled at any
time by pressing the
CANCEL key.