Troubleshooting - Craftsman 917.28936 Manual Del Operador

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

TROUBLESHOOTING
CHART:
See appropriate section in manual unless directed to Sears service center
PROBLEM
CORRECTION
Will not start
Hard to start
Engine will not
turn over
Engine clicks but
will not start
Loss of power
1
2
4
5
6
7
CAUSE
Out of fuel.
Engine
not "CHOKED"
properly.
Engine
flooded.
Bad spark
plug.
Dirty air filter.
Dirty fuel filter.
Water in fuel.
8
Loose or damaged
wiring.
9
Carburetor
out of adjustment.
10
Engine
valves
out of adjustment.
1
Fill fuel tank.
2
See "TO START
ENGINE"
in
Operation
section.
3
Wait several
minutes
before
attempting
to start.
4
Replace
spark plug.
!5
Clean/replace
air filter.
6
Replace
fuel filter.
7
Empty fuel tank and carburetor,
refill tank with fresh gasoline
and
replace
fuel filter.
8
Check all wiring.
9
See "To Adjust
Carburetor"
in
Service
and Adjustments
section.
10
Contact
a Sears or other qualified
service
center.
1
Dirty air filter.
2
Bad spark
plug.
3
Weak or dead battery.
4
Dirty fuel filter.
!5
Stale or dirty fuel.
6
Loose or damaged
wiring.
7
Carburetor
out of adjustment.
1
Clean/replace
air filter.
2
Replace
spark plug.
3
Recharge
or replace
battery.
4
Replace
fuel filter.
!5
Empty fuel tank and refill tank
with fresh, clean gasoline.
6
Check all wiring.
7
See "To Adjust
Carburetor"
in
Service
and Adjustments
section.
8
Engine
valves
out of adjustment.
1
Clutch/brake
pedal not depressed.
2
Attachment
clutch
is engaged.
3
Weak or dead battery.
4
Blown fuse.
!5
Corroded
battery
terminals.
6
Loose or damaged
wiring.
7
Faulty ignition
switch.
8
Faulty solenoid
or starter.
9
Faulty operator
presence
switch(es).
1
Weak or dead battery.
2
Corroded
battery
terminals.
3
Loose or damaged
wiring.
4
Faulty solenoid
or starter.
1
Cutting too much
grass/too
fast.
2
Throttle
in "CHOKE"
position.
3
Build-up
of grass,
leaves and
8
Contact
a Sears or other qualified
service
center.
1
Depress
clutch/brake
pedal.
2
Disengage
attachment
clutch.
3
Recharge
or replace
battery.
4
Replace
fuse.
!5
Clean
battery
terminals.
6
Check all wiring.
7
Check/replace
ignition
switch.
8
Check/replace
solenoid
or starter.
9
Contact
a Sears or other qualified
service
center.
1
Recharge
or replace
battery.
2
Clean
battery
terminals.
3
Check all wiring.
4
Check/replace
solenoid
or starter.
1
Raise cutting height/reducespeed.
2
Adjust
throttle
control.
3
Clean
underside
of mower
trash under mower.
4
Dirty air filter.
!5
Low oil level/dirty
oil.
6
Faulty spark
plug.
7
Dirty fuel filter.
8
Stale or dirty fuel.
housing.
4
Clean/replace
air filter.
5
Check oil level/change
oil.
6
Clean &regap
or changesparkplug.
7
Replace
fuel filter.
8
Empty fuel tank and refill tank
with fresh, clean gasoline.
28

Publicidad

Tabla de contenido
loading

Tabla de contenido