Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Keys
(2/Keys
(1) Oil Drain Tube
For Future Use
Slope Sheet
Your new tractor has been assembled at the factory with the exception of those parts left
unassembled for shipping purposes. To ensure safe and proper operation of your tractor
all parts and hardware you assemble must be tightened securely. Use the correct tools as
necessary to insure proper tightness.
TOOLS
REQUIRED
FOR ASSEMBLY
A socket wrench set will make assembly
easier. Standard wrench sizes are listed.
(1) 1/2" wrench
Tire pressure gauge
(2) 7/16" wrenches
Utility knife
Pliers
When right or left hand is mentioned in this
manual, itmeans when you are inthe operating
position (seated behind the steering wheel).
TO
REMOVE
TRACTOR
FROM
CARTON
UNPACK CARTON
*
Remove all accessible loose parts and
parts cartons from carton.
*
Cut along dotted lines on all four pan-
els of carton. Remove end panels and
lay side panels flat.
*
Check for any additional loose parts or
cartons and remove.
BEFORE
REMOVING
TRACTOR
FROM SKiD
TO CHECK BATTERY
1. Lift hood to raised position.
NOTE: If this battery is put into service after
month and year indicated on label (label is
located between terminals) charge battery
for minimum of one hour at 6-10 amps. (See
"BATTERY" in Maintenance
section of this
manual for charging instructions).
•
For batteryand battery cable installation
see "REPLACING
BATTERY"
in the
"Service
and Adjustments"
section
in
this manual.
Label
ADJUST SEAT
1. Sit in seat.
2. Lift up adjustment lever (A) and slide seat
until a comfortable
position is reached
which allows you to press clutch/brake
pedal all the way down.
3. Release lever to lock seat in position.
Publicidad
Tabla de contenido
