Setting Up The Tower Fan; Starting The Application - Beurer LV 200 Instrucciones De Uso

4.2 Setting up the tower fan

WARNING
Before setting up the tower fan, make sure that it is not connected to the power supply.
1. Place the tower fan flat on the ground.
2. Unscrew the large twist lock on the underside (see illustration
3. Firmly attach the two stand halves together until you hear and feel them click into place. Then
guide the mains cable through the middle of the two halves of the stand (see illustration
4. Align the spigot of the stand with the hole in the tower fan. Firmly screw the stand onto the tower
fan using the large twist lock (see illustration
5. Thread the mains cable through the cable duct. Be careful not to damage the mains cable.
6. Place the tower fan on a level and stable surface to prevent vibrations and noise.
7. Set up the tower fan in your immediate vicinity. Leave clearance of at least 30 cm on all sides around
the tower fan. Never block the air inlet and outlet.

4.3 Starting the application

1. Plug the tower fan cable into a suitable socket. The temperature is shown on the display.
2. Pull out the battery strip on the remote control.
3. Switching on the tower fan: To switch on the tower fan, press the ON/OFF button
the remote control or on the control panel). A beep sounds when the device is switched on using
the remote control. After being switched on, the tower fan runs automatically at low fan speed
and in basic mode
4. Selecting the fan speed: The tower fan can run at three different fan speeds. Use the SPEED
button (either on the remote control or on the control panel) to set your preferred fan speed. The
8
currently set fan speed appears on the display.
= low fan speed
= medium fan speed
= high fan speed
˚C
5. Selecting the mode: The tower fan has three different modes (Basic, Nature and Sleep). Use the
MODE button (either on the remote control or on the control panel) to select your preferred mode.
˚C 9
The currently set mode is shown on the display.
= Basic mode (continuous air flow)
= Nature mode (simulates winds as they are experienced in nature)
= Sleep mode (the display switches off automatically after 10 seconds)
The air flow switches between low and high speed at long intervals. The air flow runs
continuously at low fan speed. To exit Sleep mode, press any key.
6. Setting the timer: The tower fan has an optional timer (1–15 hours). The tower fan then switches off
automatically after the time set on the timer has elapsed. To set a timer, use the TIMER button
to select the desired timer time. If the TIMER button
set timer time is confirmed and
and hold the TIMER button
7. Adjusting the swing: To make the tower fan oscillate back and forth during use, press the SWING
button . To switch this function off again, press the SWING button
11
8. Switching off the tower fan: To switch the tower fan off again, press the ON/OFF button
the remote control or on the control panel). All indicators except that for the room temperature
disappear from the display. If the tower fan is not to be used for an extended period of time,
disconnect the mains plug from the socket.
.
˚C
˚C
˚C
˚C
˚C
is shown on the display. To end the timer prematurely, press
for 5 seconds.
10
A
page 3).
C
˚C
is not pressed for 3 seconds, the currently
10
17
page 3).
7
again.
11
page 3).
B
(either on
10
(either on
7