Read In Changed Configuration; On Printer; Close Configuration Program; Cleaning - Seca 465 Manual De Instrucciones Y Garantía

Read in changed
configuration on printer
Close configuration
program

6. CLEANING

6.1 Clean housing

68 •
1. Ensure that you have saved all the settings made.
2. Click on close or on the cross symbol.
The program closes.
3. Log off the SD card using the Safely remove
hardware or Eject function, depending on your
operating system.
4. Take the SD card out of the PC's memory card
reader.
5. Plug the SD card into the memory card reader of
the printer.
The changed settings are loaded.
The printer is operational with its modified settings
after about 1 minute.
1. Ensure that you have saved all the settings made.
2. Click on close or on the cross symbol.
The program closes.
The housing should be cleaned at regular intervals to
suit the usage of the printer
CAUTION!
Burns, cuts
− Do not touch the print head. This is very hot
immediately after printing.
− Do not touch the paper cutter.
− Do not hold the paper by the edges. These
too can cause cuts.
1. Ensure that the device is switched off.
2. Disconnect the power supply plug from the power
supply socket.