Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Immediately
prepare
your lawn mower for storage
at the end of the season
or if the unit
wil! not be used for 30 days or more°
LAWN
MOWER
When lawn mower is to be stored for a
period of time, clean it thoroughly,
remove
all dirt, grease,
leaves, etc.
Store in a
clean, dry area.
1o Clean
entire lawn mower (See
"CLEANING"
in the Maintenance
sec-
tion of this manual).
2.
Lubricate
as shown
in the Maintenance
section
of this manual°
3.
Be sure that all nuts, bolts, screws,
and
pins are securely
fastened.
Inspect
moving
parts for damage,
breakage
and wear.
Replace
if necessary.
4. Touch up all rusted or chipped
paint
surfaces;
sand lightly before painting.
SQUEEZE
Handle
bracket
Handle pin
HANDLE
"Youcan fold your mower handle for storage.
NOTE: The upper handle has an "anti-fold"
bracket
located on the right side of the
handle.
This bracket prevents
the upper
handle from folding forward,
which helps
protect control
cable(s)
from damage.
1o Loosen
the two (2) handle knobs on
sides of the upper handle
and allow
handle to fold down to the rear.
2.
Squeeze
the bottom
ends of lower
handle toward
each other until pins
in handle clear the brackets
and pivot
entire handle
assembly
forward and
allow it to rest on mower.
• When
setting
up your handle from the
storage
position,
you must manually
lock lower handle into mowing
position.
IMPORTANT:
When folding the handle for
storage
or transportation,
be sure to fold
the handle
as shown or you may damage
the control
cables.
Operator presence
control bar
Upper handle
Lower
Mowing
position
ENGINE
FUEL SYSTEM
IMPORTANT:
It is important to prevent
gum deposits
from forming
in essential
fuel system
parts such as carburetor,
fuel
filter, fuel hose, or tank during storage.
Also, alcohol
blended
fuels (called gasohol
or using ethanol
or methanol)
can attract
moisture
which leads to separation
and
formation
of acids during storage.
Acidic
gas can damage
the fuel system
of an
engine while in storage.
• Empty the fuel tank by starting
the en-
gine and letting it run until the fuel lines
and carburetor
are empty.
o Never use engine
or carburetor
cleaner
products
in the fuel tank or permanent
damage
may occur°
• Use fresh fuel next season.
NOTE:
Fuel stabilizer
is an acceptable
alternative
in minimizing
the formation
of
fuel gum deposits
during storage.
Add
stabilizer
to gasoline
in fuel tank or stor-
age container.
Always
follow the mix ratio
found on stabilizer
container.
Run engine
at least t0 minutes
after adding stabilizer
to allow the stabilizer
to reach the car-
buretor.
Do not empty the gas tank and
carburetor
if using fuel stabilizer.
ENGINE
OIL
Drain oil (with engine warm) and replace
with clean engine
oil. (See "ENG!NE"
in
the Maintenance
section
of this manual).
17
Publicidad
Tabla de contenido
Solución de problemas
