Bag Changing - Kenmore 116.29219 Manual De Uso

[
For best cleaning results, the dust bag
should be changed often
BAG CHANGING
NOTE: See PARTS AND FEATURES for
Bag Number.
I. Turn off and unplug vacuum cleaner from
walt outtet,
2. Remove hose from canister
3,.Depress upward
hood release and
lift canister hood
4. Disengage
cardboard tab from
red bag mount by
pulling away and
lifting up
5. Pull bag out of the
red bag mount.
6, Check the
motor safety
filter and
replace, if
necessary
Motor_A _'_"_t_ _-, , v"
- Filter ._. ':- i_ _, "
• _%_,_@. :- Red Bag
7..The red bag mount will flip forward after
removing bag. This will prevent the hood
from closing until a new bag is installed.
Note: DO NOT bend or crease the middle
of the cardboard when installing the bag
into the bag mount slots.
8o Rotate red bag
mount down and
install bag into slots
as shown, pushing
down until the
cardboard tab locks
into position and the
holes align Tuck
the bag securely
into the bag cavity so that none of it will be
pinched by the hood.
9. Close and latch canister hood
10_Reinstall hose
11. Plug cord into wall outlet
CAUTION
NEVER REUSE A DUST BAGo'very fine
materials, such as carpet freshener,
face powder, fine dust, plaster, soot,
new carpet lint, etc. can clog the bag
and cause it to burst before it is full and
may cause damage to vacuum cleaner
motor. Change bag more often when
vacuuming these materials_
CLEANING EXTERIOR AND ATTACHMENTS
1. Turn off and unplug vacuum cleaner. DO
NOT drip water on vacuum cleaner,
2oTo clean exterioq or to reduce static elec-
tricityand dust build-up, wipe outer surface
of vacuum cleaner and attachments. Use a
clean, soft cloth that has been dipped in a
solution of mild liquid detergent and water,
then wrung dry. Wipe dry after cleaning,.
CAUTION
Do not use attachments if they are wet.
Attachments used in dirty areas, such
as under a refrigerator, should not be
used on other surfaces until they are
washe& They could leave marks.
15