Kenmore 116.29219 Manual De Uso página 17

Always follow allsafety p recautions when p erforming maintenance onthePower-Mate
Electrical Shock Or Personal Injury Hazard.
Disconnect electrical supply before performing maintenance to the vacuum cleaner.
Failure to do so could result in electrical shock or personal injury from vacuum cleaner
suddenly starting,,
i BELT CHANGING AND AGITATOR CLEANING f__
TO REMOVE BELT TO REPLACE BELT !
lolnstallnew _ _
motor drive, __ "_"_.,"_,.._._'-_(( _ ....................
down then over "_'___.J_"
2. Unscrew two (2) belt path,, __#._ _._M_t_r
Power-Mate cover
"-..._ ,, -- \ Pozh
Agitator End Cap
4. To remove cover,
grasp the sides and
pull out
3. -PJrnPower-
Mate
up..Press handle
release pedal and
lower the swivel
Lift rear and side
latches up
End Cap
and remove
worn belt
6, Check and clean end cap areas., See TO
CLEAN AGITATOR section and AGITATOR
ASSEMBLY illustration for picture of
complete agitator assembly,
NOTE: See
PARTS AND
FEATURES for
Belt number
2oPlace agitator
assembly back
into Power-Mate
&Line up front [/(___'_L_
of cover and
base, Rest
cover on front
edge ofbase as
shown, Cover Base
__ 4. Rotate cover
bac , Press
__.__# "ii_,_ cover firmly until
_'_"_'>'_-_"'_'_---L_.[_Lside and rear
< ) ii tohos snap nto
"_ide RY_ place,
Latch Latches
Make sure there is no gap between the
cover and base,
5. Turn Power-Mate upside down and
replace two (2) cover screws,
17