OHAUS 100A Manual De Instrucciones página 5

Ionizer 100A
2. INSTALLATION
2.1 Package Contents
Ionizer
Instruction Manual
2.2 Installing Components
Follow the steps below to install the ionizer.
Step 1. Place the ionizer on the table next to the balance as shown below. The distance
between the ionizer and the balance should be more than 20 mm.
Step 2. Adjust the height and angle of the ionizer by loosening the two lock knobs on each
side of the ionizer and moving it to the optimal position.
Step 3. Tighten the two lock knobs.
Step 4. Connect the AC adapter to a power outlet.
AC Adapter
Figure 2-1. Place the ionizer next to the balance
Lock knobs
Figure 2-2. Adjusting the height and angle
EN-3