Kreg KBCBA Manual Del Propietário

Kreg Bench Clamp Base
Owner's Manual
Item# KBCBA & KBC3-BAS
WARNING
This product is intended for use with a Kreg Bench Clamp. When using
this product with the Kreg Mobile Project Center, read, understand, and follow the safety
precautions included with the Mobile Project Center to reduce risk of fire, electric shock, and
personal injury. When using electric tools with this product; read, understand, and follow the
tool manufacturer's instructions. Read all these instructions before attempting to use this
product. SAVE THESE INSTRUCTIONS.
Mounting the Bench Clamp Base
Assemble the Bench Clamp Base as shown. Align the hex nut
with the recess in the knob and tighten the knob, seating the nut
in the recess. The nut stays in place for future use.
ATTENTION
Mount the Bench Clamp Base in an existing ¾" (19mm)-diameter or
European-style 20mm bench-dog hole. For a workbench without bench-dog holes, you can
drill ⁄ " [14mm] holes to accommodate the Clamp Base bolt, or drill ¾" (19mm) holes to
9
16
accommodate the Clamp Base bolt as well as other standard ¾" (19mm)-hole bench-dog
accessories. Workbenches thicker than 1½" (38mm) require replacing the supplied bolt with
a ½"-13 hexhead bolt 1" (25mm) longer than the thickness of the benchtop.
⁄ "
5
16
Bench Clamp Bolt
www.kregtool.com • 800.447.8638
KBCBA
Using the Bench Clamp Base with a Kreg Bench Clamp
With the Bench Clamp Base mounted on your Kreg Mobile Project
Center table top or workbench, tighten the knob so it is snug, not
tight. This allows the Clamp Base to pivot for optimum alignment
with the workpiece. Adjust the Bench Clamp bolt as shown and
test the fit of the Bench Clamp in the Clamp Base keyhole slot.
The Bench Clamp should be snug but slide easily. Never allow the
Bench Clamp Bolt to become loose enough to allow the Bench
Clamp to pivot outside of the Clamp Base recess.
KBC3-BAS
NK9154
Version 1 - 5/2017