Hayward Swim Pro VL210T Guia De Inicio Rapido página 3

WARNING
regulations, and the National Electric Code (NEC). Hazardous voltage can shock, burn, and cause death or serious property
damage. To reduce the risk of electric shock, do NOT use an extension cord to connect unit to electric supply. Provide a properly
located electrical receptacle. Before working on any electrical equipment, turn off power supply to the equipment.
WARNING
from lawn mowers, hedge trimmers and other equipment.
WARNING
electrical equipment can cause serious or fatal electrical shock hazard.
WARNING
WARNING
electrical connections.
WARNING
– Failure to bond all electrical equipment to pool structure will increase risk for electrocution and could result in
injury or death. To reduce the risk of electric shock, see installation instructions and consult a professional electrician on how to
bond all electrical equipment. Also, contact a licensed electrician for information on local electrical codes for bonding
requirements.
Notes to electrician: Use a solid copper conductor, size 8 or larger. Run a continuous wire from external bonding lug to
reinforcing rod or mesh. Connect a No. 8 AWG (8.4 mm
pressure wire connector provided on the electrical equipment and to all metal parts of swimming pool, spa, or hot tub, and metal
piping (except gas piping), and conduit within 5 ft. (1.5 m) of inside walls of swimming pool, spa, or hot tub.
IMPORTANT - Reference NEC codes for all wiring standards including, but not limited to, grounding, bonding and other general
wiring procedures.
WARNING
– Risk of Electric Shock. Connect only to a branch circuit protected by a ground-fault circuit-interrupter (GFCI).
Contact a qualified electrician if you cannot verify that the circuit is protected by a GFCI.
WARNING
– Risk of Electric Shock . The electrical equipment must be connected only to a supply circuit that is protected
by a ground-fault circuit-interrupter (GFCI). Such a GFCI should be provided by the installer and should be tested on a routine
basis. To test the GFCI, push the test button. The GFCI should interrupt power. Push reset button. Power should be restored. If
the GFCI fails to operate in this manner, the GFCI is defective. If the GFCI interrupts power to the electrical equipment without the
test button being pushed, a ground current is flowing, indicating the possibility of an electrical shock. Do not use this electrical
equipment. Disconnect the electrical equipment and have the problem corrected by a qualified service representative before
using.
CAUTION –
marked. Do not use with storable pools. A permanently-installed pool is constructed in or on the ground or in a building such
that it cannot be readily disassembled for storage. A storable pool is constructed so that it is capable of being readily
disassembled for storage and reassembled to its original integrity.
To original purchasers of this equipment, Hayward Pool Products, Inc. warrants its filtersto be free from defects in materials and workmanship for a period of
ONE (1) year from the date of purchase, when used in single family residential applications.
The limited warranty excludes damage from freezing, negligence, improper installation, improper use or care or any Acts of God. Parts that fail or become
defective during the warranty period shall be repaired or replaced, at our option, within 90 days of the receipt of defective product, barring unforeseen delays,
without charge.
Proof of purchase is required for warranty service. In the event proof of purchase is not available, the manufacturing date of the product will be the sole
determination of the purchase date.
To obtain warranty service, please contact the place of purchase or the nearest Hayward Authorised Service Center. For assistance on your nearest Hayward
Authorised Service Center please visit us at www.hayward-pool.com.au.
Hayward shall not be responsible for cartage, removal, repair or installation labor or any other such costs incurred in obtaining warranty replacements or
repair.
For International Warranty-Contact your product supplier, or write to sales@hayward-pool.com.au.
The Hayward Pool products warranty does not apply to components manufactured by others. For such products, the warranty established by the respective
manufacturer will apply.
The express limited warranty above constitutes the entire warranty of Hayward Pool Products with respect to its' pool products and is in lieu of all other
warranties expressed or implied, including warranties of merchantability or fitness for a particular purpose. In no event shall Hayward Pool products be
responsible for any consequential, special or incidental damages of any nature.
Some states do not allow a limitation on how long an implied warranty lasts, or the exclusion of incidental or consequential damages, so the above limitation
may not apply to you. This warranty gives you specific legal rights, and you may also have other rights, which vary from state to state.
*Supersedes all previous publications.
Page 3 of 15
– Risk of Electric Shock. All electrical wiring MUST be in conformance with applicable local codes,
– To reduce the risk of electric shock replace damaged wiring immediately. Locate conduit to prevent abuse
–
Electrical ground all electrical equipment before connecting to electrical power supply. Failure to ground all
–
Do NOT ground to a gas supply line.
– To avoid dangerous or fatal electrical shock, turn OFF power to all electrical equipment before working on
This pump is intended for use with permanently-installed pools and may be used with hot tubs and spas if so
SAVE THESE INSTRUCTIONS
HAYWARD Pool Products Limited Warranty
®
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
Swim Pro® by HAYWARD® Sand Filter
2 ) [No. 6 AWG (13.3 mm 2 ) for Canada] solid copper bonding wire to the
Hayward Pool Products (Australia) Pty Ltd
PO Box 4384, Dandenong South, VIC, 3175
IS0240TC REV OZ