AVM FRITZ!WLAN 300E Instalación Y Operación página 12

Establish a Connection Using WPS Quick Connection
The WPS quick connection is the simplest and fastest way to establish a secure con-
nection between WLAN devices.
Requirements
 The WLAN base station must support the WPA or WPA2 encryption standard.
 All of the devices participating in the wireless network must support WPS and WPS
must be enabled.
In the latest FRITZ!Box models WPS is enabled by default. In older models, enable
the WPS Push-Button method in your FRITZ!Box user interface under
"WLAN / Security / WPS - Quick Connection".
 The SSID (network name) of the WLAN base
station must be set to "visible", and if
the MAC address fi lter is enabled, it must
be switched off for the initial confi gura-
tion. Both are confi gured ex works in any
FRITZ!Box.
FRITZ!WLAN Repeater: press the "WPS" button
22
Establishing a Connection
1. Press the WPS button on the FRITZ!WLAN Repeater until the "WLAN" LED begins
fl ashing.
FRITZ!Box: press the "WLAN" button
Push for approx.
2. Within two minutes, press the "WLAN" button on your FRITZ!Box and hold it down
6 seconds
until the "WLAN" LED begins fl ashing.
3. The FRITZ!WLAN Repeater and the FRITZ!Box now establish a secure wireless
connection with each other automatically. The "WLAN" LEDs on both devices light
up and remain on.
This concludes the WPS quick connection. Now you can confi gure the FRITZ!WLAN Re-
peater in a user interface. For more information, continue reading from page 26.
Push for approx.
6 seconds
23