Assembly - Remington M15012US Manual Para El Usuario

Ocultar thumbs Ver también para M15012US:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

ASSEMBLY

Note: Some models are pre-assembled. Assembly
is not needed on these models. See Saw Chain
Tension Adjustment
WARNING: Cutting edges on chain
are sharp. Use protective gloves when
handling chain.
IMPORTANT: Do not clamp chain saw
in vise during assembly.
1. Lay chain out flat.
2. Loosen and remove guide bar nut and sprocket
cover.
3. Rotate guide bar retainer so that it is positioned
parallel to guide bar slot (see Figure 2).
4. Install guide bar onto saw body. Assemble
center slot of guide bar onto guide bar bolt
and guide bar retainer. Note: Make sure the
head of the guide bar retainer slides through
the guide bar slot as shown in Figure 2.
Drive Sprocket
Figure 2 - Unlocking Guide Bar Retainer
5. Rotate guide bar retainer 90 degrees as shown
in Figure 3.
Drive Sprocket
Figure 3 - Locking Guide Bar Retainer
www.Desatech.com
www.remingtonpowertools.com
For parts contact: www.PartsFor.com
6. Place chain around drive sprocket, along top
groove of guide bar, and around guide bar nose.
Note: Make sure cutting edges of chain are
facing in right direction. Position chain so
cutting edges on top of guide bar face guide
bar nose (see Figure 4 and indicator on side
cover of saw).
CAUTION: Do not place chain
on saw backwards. If chain is back-
wards, saw will vibrate badly and will
not cut.
Guide Bar
Figure 4 - Saw Chain Direction
7. Before installing sprocket cover to saw body,
turn the chain tensioning screw fully counter-
Guide Bar Retainer
clockwise until it stops. This will position the
Positioned Parallel
adjusting block towards the end of the chain
to Guide Bar Slot
tensiong screw. (See Figure 5)
Guide Bar
Chain Tensioning
Screw
Guide Bar Retainer
Figure 5 - Chain Tensioning Screw and
Rotated 90 Degrees to
Adjustment Block Location
Guide Bar Slot
10
Towards
Guide Bar
Nose
Guide Bar
Cutting
Edge
Turn tensioning
screw to move
Adjustment Block

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

M15014asM30016usM30016asM30016awM35016aw

Tabla de contenido