Publicidad
Idiomas disponibles
Idiomas disponibles
[]
Grill Head to Cart
This step requires two people to lift and position grill head onto cart.
Remove the tie wraps securing regulator hose to underside of grill head. Pull hose and igniter
wires out to side of grill head.
[]
Carefully lower the grill head onto the cart. Make sure the regulator hose and igniter wires
are hanging outside the cart. Open lid and attach head to cart with (4} M6x13 screws and
M6 compression washers.
[]
Slide grease tray into bottom of firebox from back. Make sure the grease drainage hole is on
the right side, as seen from the back of the grill.
[]
Align back rail holes with holes on side panels and firebox. Attach back rail with (4} M4xl0
screws.
M6X13 screw
Qty: 4 pcs
M6 compression washer
Qty: 4 pcs
M4XIO screw
Qty: 4 pcs
23678-41100309
_ 21
Publicidad
