Publicidad
Idiomas disponibles
Idiomas disponibles
QUICK PROGRAMMING GUIDE 912-TT 2xDVB-S/S2 TO DVB-T
Program by
Channel
Channel
Frequency
Channel table
BG CCIR
Channel
21
Frequency
471.25
Attenuation
14
Off set
0
Bandwith
8
Mode
8K
8K
2K
Modulation
64QAM
FEC COFDM
7/8
Guard interval
1/32
Cell ID
0
Services
(COD) Coded service 1
(COD) Coded service 2
(FTA) Free to air service 1
(FTA) Free to air service 2
(FTA) Free to air service 3
BW total
81%
Orig Net Id
1
TSID
1078
NIT table
Set the programming switch of the 912-TT module to the OFF position. The programming
MHz
dB
MHz
MHz
CAM
✓
15%
TV
✓
TV
13%
✓
TV
17%
✓
TV
17%
✓
TV
19%
Network ID
1
No information
Not generated
Valid
Invalid
indicator light will now go out.
Select the programming mode for the output of the
OK++OK+T
module: channel or frequency. Then press T to transmit.
Select the standard for the output channel. Then press
OK++OK+T
T to transmit.
If the output is programmed by channel, it is possible to
Keypad + T
enter the channel using the numeric keypad. Alternatively,
o
you can select a channel from the pull-down list. When
OK++OK+T
you have confi rmed your choice by pressing OK, press
T to transmit.
If the output is programmed by frequency, enter the
Keypad + T
frequency using the numeric keypad. Then press T to
transmit.
Keypad + T
Enter the attenuation at the output of the module
or
using the numeric keypad. Then press T to transmit.
OK++OK+T
Select the offset of the output frequency from the options
OK++OK+T
available. Then press T to transmit.
Select the bandwidth of the output channel: 6, 7 or 8
Keypad + T
or
MHz. You can do this using either the numeric keypad or
OK++OK+T
the pull-down menu. Then press T to transmit.
Select the number of carriers mode in the output channel.
OK++OK+T
Then press T to transmit.
Select the type of modulation of the output channel. Then
OK++OK+T
press T to transmit.
Select the output forward error correction rate (FEC
OK++OK+T
COFDM). Then press T to transmit.
Select the guard interval of the output signal. Then press
OK++OK+T
T to transmit.
You can enter a number of up to 5 digits as the cell
Keypad + T
identifi er using the numeric keypad. Then press T to
transmit.
Press the READ key to obtain a reading of the services
READ
available in the input transponder.
Select the services that you wish to distribute, marking
them with
OK++OK
that you should not use more than 90% of the available
BW.
Once the desired services have been selected, press T
T
to transmit.
Using the numeric keypad, you can enter a TS identifi er
Keypad + T
(TSID), should that be necessary for your installation.
Then press T to transmit.
The status of the NIT table is shown in grey if no relevant
information is available; in green if the NIT table is
correct; and in red if the NIT table contained in the
module is incorrect.
✓
(by pressing the OK key). It is recommended
ENG
Publicidad
