Publicidad
Idiomas disponibles
Idiomas disponibles
Frequency
471.25
Attenuation
14
Off set
0
0
+1/6
-1/6
+2/6
-2/6
+3/6
-3/6
Bandwith
8
Mode
8K
8K
2K
Modulation
64QAM
QPSK
16QAM
64QAM
FEC COFDM
7/8
1/2
2/3
3/4
5/6
7/8
Guard interval
1/32
1/32
1/16
1/8
1/4
Cell ID
0
Services
(COD) Coded service 1
(COD) Coded service 2
(FTA) Free to air service 1
(FTA) Free to air service 2
(FTA) Free to air service 3
BW total
81%
Orig Net Id
1
TSID
1078
Set the programming switch of the 912-TT module to the OFF position. The programming
QUICK PROGRAMMING GUIDE 912-TT
MHz
dB
MHz
MHz
CAM
✓
TV
15%
✓
TV
13%
✓
TV
17%
✓
TV
17%
✓
TV
19%
Network ID
1
indicator light will now go out.
If the output is programmed by frequency, enter the
Keypad + T
frequency using the numeric keypad. Then press T to
transmit.
Keypad + T
Enter the attenuation at the output of the module
or
using the numeric keypad. Then press T to transmit.
OK+
+OK+T
Select the offset of the output frequency from the options
OK+
+OK+T
available. Then press T to transmit.
Select the bandwidth of the output channel: 6, 7 or 8
Keypad + T
or
MHz. You can do this using either the numeric keypad or
OK+
+OK+T
the pull-down menu. Then press T to transmit.
Select the number of carriers mode in the output channel.
OK+
+OK+T
Then press T to transmit.
Select the type of modulation of the output channel. Then
OK+
+OK+T
press T to transmit.
Select the output forward error correction rate (FEC
OK+
+OK+T
COFDM). Then press T to transmit.
Select the guard interval of the output signal. Then press
OK+
+OK+T
T to transmit.
You can enter a number of up to 5 digits as the cell
Keypad + T
identifi er using the numeric keypad. Then press T to
transmit.
Press the READ key to obtain a reading of the services
READ
available in the input transponder.
Select the services that you wish to distribute, marking
them with
OK+
+OK
that you should not use more than 90% of the available
BW.
Once the desired services have been selected, press T
T
to transmit.
Using the numeric keypad, you can enter a TS identifi er
Keypad + T
(TSID), should that be necessary for your installation.
Then press T to transmit.
✓
(by pressing the OK key). It is recommended
ENG
Publicidad
