Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
The twilight detector can automatically switch the light on or off depending on the ambient
light. The ambient temperature and humidity do not affect its operation. This is not only
convenient, but also practical as you can control the lighting only at night. It is used for road
lighting, garden lighting, etc.
SPECIFICATION
• Power source: 220-240V~
• Power frequency: 50/60Hz
• Rated current: 20A
• Ambient light: <5-50LUX (adjustable)
• Working temperature: -20~+40ºC
• Working humidity: <93%RH
• IP 44 Protection degree
INSTALLATION
• Loosen the two screws at the bottom, remove the black bracket and the plastic cover
(see figure 1).
• Find the cable hole at the bottom and pass the power cable through the hole. Connect
the power cable to the connection strip according to the wiring diagram.
• Install the twilight detector in the correct location with the plastic bracket and according to
the correct installation site, installing it with the screws in the proper way.
TEST
• Move the LUX control to position (-) and switch on the power.
• When testing during the day, the detector should be covered with an opaque cloth.
• When the detector is covered with the opaque cloth, but it detects ambient light below 5
lux, the lamp will be on.
• When the fabric is removed, the lamp will automatically turn off.
• By sliding the LUX control to the (+) position, the lamp will be on if there is an ambient
light level of less than 50LUX.
NOTE
• In front of the detector, there should be no obstacles affecting the amount of natural light
it receives.
• In front of the detector, there should be no objects swaying.
• Do not install the detector under light or in places where light can be focused on the
detector.
Surface/Post Twilight Detector
ENG
Publicidad
