Rockford Fosgate 3Sixty Manual De Instalación Y Funcionamiento página 11

New Setup
4. Click on the inputs you have connected to your 3Sixty unit. Clicking the
Cancel icon will return you to the main screen.
NOTE:The 3Sixty can be set up to create a 6-channel output with only 2-channels
(Left and Right) of input. However, for the best sound stage, it is strongly
recommended to connect into all of the main inputs (AUX not required).
The system will SUM if you are not using the 6 main inputs (all left
channels will form one signal and all right channels will form one signal).
Stereo imaging will be maintained but your fader will cease to function.
5. Select "NEXT" to continue. Follow the instructions to adjust your amplifier
for system setup.
A: Set the all the gains on the amplifier to minimum.
B: Insert the "3Sixty Setup Disc" CD into the vehicle's main CD player
C: Play track 1 and set the player to repeat the track.
NOTE:If you do not have a repeat function on your CD player, ensure track
1 plays during the entire setup process.
6. Select "NEXT" to continue. Follow the instructions to adjust your source unit
for system setup.
A: If the source unit does not clip at maximum volume, then set the volume
to maximum, otherwise set the volume 3/4 of the way up.
B: Set the source unit's Balance/Fader to center.
C: Set the source unit's Bass and Treble to 0.
7. Select "NEXT" to continue. Follow the instructions to adjust your 3Sixty for
system setup.
NOTE:The 3Sixty can be set up to create a 6-channel output with only 2-channels
(Left and Right) of input. However, for the best sound stage, it is strongly
recommended to connect into all of the main inputs (AUX not required).
The system will SUM if you are not using the 6 main inputs.
A: Locate LEVEL control next to the input RCAs, and the signal presence
(SLP) and clipping (CLP) LED's located under the RCAs. If there is an
input whose SLP blue LED is not on, then use a small flathead screwdriver
to turn the "LEVEL" control up (clockwise) until the blue LED comes on. If
at maximum setting the blue LED does not come on, turn it back all the way
down and recheck your connections.You may need to recheck the Bass and
Treble settings or use a different input.
NOTE:If you still can't get the signal presence (SLP) LED to come on, troubleshoot
the system. If the problem still persists, call customer service.
B: Using a small flathead screwdriver, turn the "LEVEL" control up (clockwise)
until the clipping (CLP) indicator just begins to blink red.Turn the level
down (counter-clockwise) slightly if the indicator is steady red.The ideal
setting is where the CLP red LED is blinking.
NOTE:You only need to adjust the levels for the inputs being used.
8. When adjustments are completed, select "NEXT" to continue.
A: The screen will show a status bar of transferring data to the 3Sixty unit.
B: The screen will ask you to wait while it mutes the audio.
C: After a few moments the audio will be restored.
9. New Setup is complete and "Click on a speaker to edit" (Tuning Screen) will appear.You may now
continue tuning your system by selecting any of the speakers shown on the image, see Tuning Your
System - EQ on page 12. Or, you can select DONE to exit.
If you selected "DONE", you will be asked to save the current file. Either select "Yes" to
3Sixty.2:
save the file (see Loading and Saving a File at the end section of Operation), or "No, thanks"
to continue exiting without saving the file to the Palm device.The current setup file is
maintained on the 3Sixty unit and will be used when you access the unit.
O -S
PERATION ETUP
11