Function & Control - Forney 700P Manual De Instrucciones

PROPERLY ASSEMBLED PLASMA TORCH
PROPER ASSEMBLY SEQUENCE OF PLASMA CONSUMABLES
In the event that your plasma torch consumable parts are not already assembled, use the
following procedure:
1. Position the torch with the shield cup facing upward to prevent these parts from falling out.
2. Install the electrode, air diffuser ring, and nozzle.
3. Use the included wrench to tighten the ELECTRODE. A loose ELECTRODE can further loosen
during operation and damage the PLASMA TORCH.
4. Hand-tighten the shield cup until it is seated on the torch head. If resistance is felt when
installing the cup, check the threads before proceeding.
5. Included in the parts bag with your machine are 1-each of an electrode and nozzle for future
use in replacing worn parts. See Torch Maintenance for replacement procedure.
Function & Control
2
3
4
5
10
SHIELD CAP
HAND
RETAINING CAP
CUTTING TIP
GAS DIFFUSER
ELECTRODE
TORCH HEAD
ASSEMBLY
WWW.FORNEYIND.COM
Contact
MAXIMUM
Two sets of consumables are provided.
PERFORMANCE
cutting
1. MAXIMUM PERFORMANCE
- Maximizes cut speed and thickness
MAXIMUM
2. MAXIMUM VERSATILITY
VERSATILITY
- Should be used on thinner material,
in tight spaces, or where maximum
input power is not available.
- Use smaller diameter tip when cutting
with 120V input.
8
7
6
1
9
15