Crafstman 580.752370 Manual Del Operador página 6

Yourpressure washer requires s omeassembly a ndis
readyforuseonlyafterit hasbeenproperly serviced
withtherecommended oil andfuel.
if you have any problems with the assembly of
your pressure washer, please call the pressure
washer helpline at 1-800-222-3136.
UNPACK THE PRESSURE WASHER
1. Remove everything from carton except pressure
washer.
2. Open carton completely by cutting each corner
from top to bottom.
3. Remove pressure washer from carton.
CARTON CONTENTS
Check all contents. If any parts are missing or damaged,
call the pressure washer helpline at 1-800-222-3136.
The main unit
Handle
Accessory tray
Spray gun
High pressure hose
Nozzle extension with quick connect fitting and
spray tip holder
• Engine oil
• Parts bag (which includes items listed below)
• Operator's manual
• Registration card
• Safety goggles
• Bag containing 5 multi-colored quick connect
spray tips
• Handle fastening hardware kit (which
includes):
• Carriage bolt (2)
• Plastic knobs (2)
• Tree Clips (4)
Become familiar with each piece before assembling
the pressure washer. Check all contents against the
illustration on page 5. If any parts are missing or
damaged, call the pressure washer helpline at
1-800-222-3136.
ASSEMBLING YOUR PRESSURE
WASHER
Your Craftsman high pressure washer was mostly
assembled at the factory. However, you will need to
perform these tasks before you can operate your
pressure washer:
1. Fill out and send in registration card.
2. Attach handle and accessory tray.
3. Add oil to engine crankcase.
4. Add fuel to fuel tank.
5. Connect pressure hose to spray gun and pump.
6. Connect water supply to pump.
7. Attach nozzle extension to spray gun.
8. Select/attach quick connect spray tip to nozzle
extension.
Attach Handle and Accessory Tray
1. Place handle assembly onto handle supports
connected to main unit. Make sure holes in handle
align with holes on handle supports.
Align Holes E-_._.___..v_.1_,,_,"_
Handle
Supports
NOTE: It may be necessary to move the handle
supports from side to side in order to align the handle
so it will slide over the handle supports.
2. Insert carriage bolts through holes from front of
unit and attach plastic knob from back of unit.
Tighten by hand.