BLACK&DECKER BDV158 Manual Del Usuario página 5

rinse immediately with clean water and seek immediate
medical attention.
Chargers
Your charger has been designed for a specific voltage.
Always check that the mains voltage corresponds to the
voltage on the rating plate.
Warning! Never attempt to replace the charger unit with a
regular mains plug.
Use your Black & Decker charger only to charge the battery
in the tool with which it was supplied. Other batteries could
burst, causing personal injury and damage.
Never attempt to charge non-rechargeable batteries.
Have defective cords replaced immediately.
Do not expose the charger to water.
Do not open the charger.
Do not probe the charger.
The battery must be placed in a well ventilated area when
charging.
DO NOT OVERCHARGE:
AC recharge up to 30 hours maximum.
DC recharge up to 4 hours maximum.
After recharge, disconnect the charging adapter and wait 5
minutes before use.
The following symbols are found on your charger:
Your charging base is double insulated; therefore
no earth wire is required.
Fail-safe isolating transformer. The mains supply
is electrically separated from the transformer
output.
The charger automatically shuts off if the
130 o C
ambient temperature becomes too high. As a
consequence the charger will be inoperable. The
charging base must be disconnected from the
mains supply and taken to an authorised service
centre for repair.
The charging base is intended for indoor use
only.
Electrical safety
This tool is double insulated; therefore no
earth wire is required. Always check that the
power supply corresponds to the voltage on the
rating plate.
If the supply cord is damaged, it must be replaced by the
manufacturer or an authorised Black & Decker Service
Centre in order to avoid a hazard.
Features
This appliance includes some or all of the following features:
1. Two replaceable quartz halogen bulbs
2. Rubber ring guard
3. Carry handle
4. Mains charger input socket
5. 12 Vdc charging socket
6. 3-position light mode switch
7. Trigger with trigger guard
8. Battery status LED indicator
9. Vehicle dc power cord
10. Mains charging adaptor
11. 12 Vdc accessory outlet
12. Twin LED area lights
Charging the spotlight (fig. A - C)
This spotlight is shipped in a partially charged state. Charge
the spotlight before first use using the mains charging
adaptor (10) for 20-30 hours or until the green battery status
LED (8) lights.
Charge after each use until the green battery status
LED (8) lights.
To check the battery charge status at any time, press the
battery status pushbutton (8).
The LED Indicators (8) display the level of charge.
One red LED indicates that the unit should be charged soon.
Two red LEDs indicate a medium level of charge.
Three red LEDs indicate a high level of charge.
The green LED lights to show a fully charged unit.
Charging with the mains charger (fig. A & B)
Warning! Do not connect the mains charger and the 12 Vdc
charger at the same time.
Make sure that the spotlight and the LED area lights are off
(the light mode switch is not set to AREA and the trigger (7)
is not pressed).
Disconnect any 12 Vdc appliances from the 12 Vdc
accessory outlet (11).
Warning! Do not charge for longer than 30 hours.
Warning! Do not turn on any lights or operate any appliances
through the 12 Vdc accessory outlet (11) when using the mains
charger.
Plug the supplied mains charging adapter (10) into the
charging socket (4) (fig. B).
Insert the mains charging adaptor (10) into a mains power
socket.
Charge until the green battery status LED (8) lights
(approximately 20-30 hours).
When charging is complete, wait for 5 minutes before
using the spotlight.
ENGLISH
5