Trouble Shooting Guide - Magic Chef HMCF9W2 Manual Del Usuario

Ocultar thumbs Ver también para HMCF9W2:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

TROUBLE SHOOTING GUIDE

You can solve many common freezer problems easily, saving you the cost of a possible service call.
Try the suggestions below to see if you can solve the problem before calling for service.
PROBLEM
Freezer does not operate.
Compressor turns on and off frequently.
Temperature inside the freezer is too warm.
Temperature inside the freezer is too cold.
Temperature of external freezer surface is warm.
Popping or cracking sound when compressor
comes on.
Bubbling or gurgling sound, like water boiling.
Vibrations.
POSSIBLE CAUSE
Not plugged in.
The circuit breaker tripped or a blown fuse.
The room temperature is hotter than normal.
A large amount of food has been added to the
freezer.
The door is opened too often.
The door is not closed completely.
The temperature control is not set correctly.
The door gasket does not seal properly.
The freezer does not have the correct
clearances.
The freezer has recently been disconnected for a
period of time. 4 hours are required for the
freezer to cool down completely.
Temperature control is set too warm. Turn the
control to a cooler setting and allow several hours
for the temperature to stabilize.
Door is kept open too long or is opened too
frequently.
Warm air enters the freezer every
time the door is opened.
often.
The door is not closed completely.
The door gasket does not seal properly.
A large amount of warm or hot food might have
been stored recently. Wait until the freezer has
had a chance to reach its selected temperature.
The freezer has recently been disconnected for a
period of time.
4 hours are required for the
freezer to cool down completely.
Temperature control is set too cold.
control to a warmer setting and allow several
hours for the temperature to stabilize.
The exterior freezer walls can be as much as
30 ƒF warmer than room temperature.
normal while the compressor works to transfer
heat from inside the freezer cabinet.
Metal parts undergo expansion and contraction,
as in hot water pipes. This is normal. Sound will
level off or disappear as freezer continues to run.
Refrigerant (used to cool freezer) is circulating
throughout the system. This is normal.
Check to assure that the freezer is on a level
surface.
Floor is uneven or weak. Freezer rocks on the
floor when it is moved slightly. Be sure floor can
adequately support freezer. Level the freezer by
putting wood or metal shims under part of the
freezer.
The freezer is touching the wall.
freezer and move it from the wall.
Open the door less
Turn the
This is
Re-level the

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido