Troubleshooting - Waxman LeakSmart Manual De Instalación Y Funcionamiento

LeakSmart Water Heater Kit

Troubleshooting

Problem
Status light does not light
No water comes out of hot side of faucet
No water comes out of hot or cold side of faucet
LeakSmart Valve does not operate
What to Check
- Make sure there is power to the outlet.
- Unplug AC Power Adaptor cord from Control
Panel and plug back in.
- If an AC Power Adaptor Extension Wire was
used, unplug both ends and reconnect.
- Make sure fresh batteries are in the Control
Panel.
- Push Open button to make sure LeakSmart
Valve is open.
- Make sure the manual cold water valve is
open.
- Make sure a manual hot water valve was not
accidentally closed.
- Make sure main water shut-off valve is
open.
- Make sure both sides of Leak Sensor are dry.
- Make sure there is power to the outlet.
- Unplug AC Power Adaptor cord from Control
Panel and plug back in.
(continued)
14.
Troubleshooting
Problem
LeakSmart Valve does not operate (continued)
Leak Sensor becomes wet but LeakSmart Valve
does not close
LeakSmart Water Heater Kit
What to Check
- Unplug 4-pin connector from Control Panel
and reconnect.
- Locate plug connection between Control
Panel and LeakSmart Valve. Unplug the
connection and reconnect, making sure
arrows on side of plugs line up.
- If an AC Power Adaptor Extension Wire was
used, unplug both ends and reconnect.
- Make sure fresh batteries are in the Control
Panel.
- Unplug long flat wire from Leak Sensor
and reconnect.
- Make sure there is power to the outlet.
- Unplug AC Power Adaptor cord from
Control Panel and plug back in.
- Unplug 4-pin connector from Control
Panel and reconnect.
(continued)
15.