Installing The Unicom Board - Sartorius YDO02C-232 Instrucciones De Instalación

Installing the UniCOM Board

§ Connect the ribbon cable: Insert the ribbon cable into the applicable slot on the interface
module (YDO0.SW-232, YDO0.SW-485/422, YDO0.SW-AO, YDO0.SW-DIO).
§ Plug the 3 PCB mountings into the interface module.
§ Plug the interface module into the digital PCB of the scale:
Insert the connector of the interface module into the corresponding port on the digital
PCB until the PCB mountings snap into place.
§ Insert the ribbon cable of the interface module into the applicable slot on the connector
board.
$ In the case of interface modules YDO0.SW-485/422 und YDO0.SW-AO: Configure the
interface module (see "Configuring the Modules", page 12).
§ Fasten the connector belonging to the interface module (including the connector board)
into the applicable opening on the new YAS0.SW-CON rear wall panel (top): Fasten the
2 screws in the connector mounting.
§ Fasten the RS-232 interface (including the connector board) into the applicable opening
on the new rear wall panel (bottom): Fasten the 2 screws in the connector mounting.
§ Seal hole 2 with the cap supplied if no board with a PS/2 port is to be installed.
§ Fasten the rear wall panel to the scale: Fasten the 6 screws.
$ Where applicable, attach labels to the rear wall panel to identify the interfaces.
Setting the UniCOM interface for operation
After installing the interface module in the indicator and configuring it, set the UniCOM
interface for the intended function with the aid of the operating menu. See the "Settings"
section for this purpose. The "Configuration" section of the Signum operating instructions
contains further explanations about this.
9