Troubleshooting - Signature Kitchen Suite SKSCF1801P Manual Del Propietário

30 TROUBLESHOOTING

TROUBLESHOOTING
A: The default setting for the freezer is 0° Fahrenheit (-18° Celsius). Adjust these settings as necessary
the display then press and hold the Freezer and Smart Grid buttons until you hear a beep and the
settings in the display change.
A: Continually press the
The numbers will cycle from highest to lowest and then return to the highest again with continuous
pressing.
A: This may happen if you do not have a water source attached to your freezer and the icemaker is
turned on. If you do not have a water source attached to the freezer you should turn the icemaker off
on the control panel.
A: This is a normal part of the icemaker cycle. The icemaker tray may appear level or with a slight tilt.
The change in position is to assist in the freezing process.
The freezer is in Demo Mode. This mode disables cooling to save energy while the appliance is on
A:
press and hold the Freezer and Water Filter Reset buttons until you hear a beep and the temperature
setting appears in the display. Use the same procedure to return the freezer to Demo Mode, if
desired.
button on the control panel until the desired temperature appears.