Channel Master DVR+ Guia De Inicio Rapido página 10

Signal Issues
Missing
Channel
Remote
Control Issues
DVR Issues
6
Troubleshooting Troubleshooting
• Verify that the coax cable to the over-the-air antenna
is connected to both the RF IN port on the back of
the receiver (hand-tighten only) and to the over-the-
air antenna.
• Verify that your antenna has not been moved out
of proper alignment. This can cause signal loss on
some or all channels.
• Reset the receiver by pressing and holding the
POWER button located on the front panel. Verify that
the LED is red or bright blue.
• If a reset doesn't work (LED is dim blue), then power
off the receiver (press the POWER button), unplug
it from the outlet for 15 seconds, and plug it back in.
Power the receiver back on.
• The DVR+ is only able to tune to digital channels and
will not tune to a channel that is still broadcasting in
analog.
• Visit antennaweb.org to find out which channels in
your area are broadcasting in digital or analog.
• Replace batteries with 2 AAA batteries. Be sure the
batteries are installed as indicated on the diagram
inside the battery compartment.
• Verify that event timers are set as DVR timers, not as
Reminder timers.
• If you would like to keep more recordings than there
is space on the hard drive, consider purchasing a
USB external hard drive and connecting it to the USB
port for additional storage.