BOB Gear
Adjusting the Shock Setting
1� Remove Child From Seat
2� Set Shock Setting
Depress shock release knob
and simultaneously pull toward
back of stroller, sliding knob
into preferred position. Knob will
snap into place when in correct
position.
Position 1 is a SOFTER shock
setting recommended for
children 40 lbs (18�1 kg) or less�
Position 2 is a FIRMER shock
setting recommended for
children weighing 41 to 75 lbs
(18�2 - 34 kg)
NOTE: Every time the stroller is
folded, stroller shocks default to
position 1.
3� REPEAT on opposite side�
10
Setting the Parking Brake
The parking brake prevents the
stroller from moving while loading
and unloading. The parking brake is
not designed as a stopping brake.
To set the parking brake, press down
on the foot pedal – making sure the
locking pin fully engages the locking
disk.
LOCKED POSITION
To ensure the brake is set properly,
attempt to roll the stroller forward
and backward after setting the
brake. If the stroller will not roll, the
brake is set properly.
To release the parking brake, lift up
on the foot pedal with your foot until
the brake bar springs up into the fully
unlocked position.
UNLOCKED POSITION
Securing the Child in the Seat
1� Set Parking Brake
Rotate parking brake down into
locked position.
NOTE: Rear wheels should not
rotate when parking brake is set.
2� Place Child In Seat
Slip one shoulder strap over each
shoulder. Position buckle strap
between legs.
Shoulder Strap
Buckle Strap
3� Fasten Shoulder Straps
Insert both shoulder strap
tongues into the buckle.
Buckle
NOTE: Buckle strap should be
adjusted to have a snug fit.
RAMBLER User Guide
4� Adjust Shoulder Strap Height
Adjust height of shoulder strap
to fit just above child shoulder
height.
5� Adjust Shoulder Straps
Slide comfort pads down for
access to buckles. Slide buckle
up or down to adjust straps. Seat
harness should fit snug and be
comfortable.
6� Tighten Lap Strap
Adjust lap strap to fit snug and be
comfortable.
Lap Strap
11