Craftsman 917.25025 Manual De Usuario página 10

Pivot the integrated washer end ofanti-
sway bar ( S) t owards mower deck b racket
onright s ide ofmower. Insert integrated
washer end ofbar i nto hole i nrear mower
bracket (D). M ove m ower asneeded to
insert integrated washer end ofbar i nto
rear m ower bracket (D).
Secure w ithsmall washer andsmall
retainer spring a sshown.
A. Mower Side S uspens,on Arms
_____
Q. Def,ector Shie,d _4_ _./" _Z! _ _
5. INSTALL ANTI-SWAY BAR (S)
(IF EQUIPPED) , _ _ \
I_::
Towards Towards "ll_/
I_'_ Transaxle Mower Deck _'_J
_1 _/ D- n,ght Side Rear M°wer Bracket[i s . Anti-sway Bar
I 90° End Integrated Washer End I T. Transaxle Bracket
• From right side of mower, first insert
90 ° end of anti-sway bar (S) into hole in
transaxle bracket (T), located near left
rear tire in front of transaxle.
NOTE: Flashlight may be helpful•
Anti-Sway ,_-'-,:- .... ...,
Bar(S) ._ . .:.' _ ; ,
Location _._ " ....... _
• .. ,._,:.:.. ,
Transaxie Bracket tq-)
Located Between Rear Tires
D. R_ghtSide Rear Mower Bracket
S. Anti-Sway Bar
Transaxle Bracket
6. ATTACH MOWER SIDE SUSPENSION
ARMS (A) TO CHASSIS
Pos ition front hole in side s uspens ion arm
(A) over pin on outside of tractor chassis
and secure with large washer and large
retainer spring (B).
Repeat on opposite side of tractor.
A. Mower Side Suspension Arms
B. Retainer Spring
D. R_ghtSide Rear Mower Bracket
NOTE: Depending on model, bracket (T) may
be different than shown but hole for anti-sway
bar will be in same position/location.
7. ATTACH REAR LIFT LINKS (C)
• Insert rod end of rear lift link (C) into hole
(U) in tractor lift shaft suspension arm
and pivot link down to mower.
Lift rear corn er of mower and position slot
in link assembly over pin on rear mower
bracket (D) and secure with largewasher
and large retainer spring.
• Repeat on opposite side of tractor.
10